Isuzu Ascender 2003-05

Brake Caliper

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Raise and safely support the vehicle.
  4.  
  5. Remove or disconnect the following:

    Rear wheels
     
    Brake hose and cap the line. Discard the copper washers.
     
    Retainers from caliper and remove caliper
     

  6.  

To install:

  1. Coat the caliper guide pin with a high temperature silicone brake lubricant. Make sure the lubricant does not get on the pads.
  2.  
  3. Install or connect the following:

    Caliper over rotor, and onto mounts
     
    Retainers, and tighten to 23 ft. lbs. or (31 Nm)
     
    Brake hose with new washers, and tighten to 33 ft. lbs. (44 Nm)
     

  4.  
  5. Bleed brake system.
  6.  
  7. Install tires.
  8.  
  9. Refill the master cylinder and pump pedal to attain full brake pedal before Road-testing the vehicle.
  10.  

  1. Before servicing the vehicle, refer to the precautions section.
  2.  
  3. Raise and safely support the vehicle.
  4.  
  5. Remove or disconnect the following:

    Rear wheels
     
    Brake hose and cap the line. Discard the copper washers.
     
    Retainers from caliper and remove caliper
     

  6.  

To install:

  1. Coat the caliper guide pin with a high temperature silicone brake lubricant. Make sure the lubricant does not get on the pads.
  2.  
  3. Install or connect the following:

    Caliper over rotor, and onto mounts
     
    Retainers, and tighten to 23 ft. lbs. or (31 Nm).
     
    Brake hose with new washers, and tighten to 33 ft. lbs. (44 Nm).
     

  4.  
  5. Bleed brake system.
  6.  
  7. Install tires.
  8.  
  9. Refill the master cylinder and pump pedal to attain full brake pedal before Road-testing the vehicle.
  10.  

 
label.common.footer.alt.autozoneLogo