Isuzu Cars and Trucks 1981-1991

Center Bearing

Print

REMOVAL AND INSTALLATION
  1. Remove the driveshaft assembly from the vehicle as outlined in this Section.
  2.  
  3. Remove the locknut and flange with a gear puller.
  4.  
  5. Remove retainer bolt and retainer.
  6.  
  7. Remove the supporting ring and cushion rubber.
  8.  
  9. Remove the bearing assembly using a gear puller.
  10.  

To install:

  1. Install the bearing assembly and repack with grease.
  2.  
  3. Install the cushion rubber and support ring.
  4.  
  5. Install the retainer, bolt, flange and locknut.
  6.  
  7. Torque the locknut to 90 ft. lbs. (122 Nm).
  8.  



Click image to see an enlarged view

Fig. Center bearing assembly

 
label.common.footer.alt.autozoneLogo