Isuzu Cars and Trucks 1981-1991

Headlight Switch

Print

REMOVAL AND INSTALLATION
RWD I-Mark, Early P'up and Trooper
  1. Disconnect the negative battery cable.
  2.  
  3. Using a small screwdriver, loosen the knob set screw and remove the switch knob.
  4.  
  5. Remove the retaining nut, being careful not to damage the instrument panel.
  6.  
  7. Remove the switch and disconnect the wiring.
  8.  

To install:

  1. Install the switch and connect the wiring.
  2.  
  3. Install the retaining nut and knob.
  4.  
  5. Connect the battery cable and check operation.
  6.  



Click image to see an enlarged view

Fig. Headlight switch RWD I-Mark, early P'up and Trooper

FWD I-Mark, Impulse and Stylus
  1. Disconnect the negative battery cable.
  2.  
  3. Remove the instrument cluster hood as outlined in the "Instrument Cluster" section in this Section.
  4.  
  5. Remove the headlight switch from the left side of the cluster hood.
  6.  
  7. Install the switch in the hood and reinstall the hood onto the instrument panel.
  8.  
  9. Connect the battery cable and check operation.
  10.  

Late Model P'up, Amigo and Rodeo
  1. Disconnect the negative battery cable.
  2.  
  3. Remove the instrument cluster as outlined in this Section.
  4.  
  5. Loosen the switch screws and remove the switch.
  6.  
  7. Install the switch and tighten screws.
  8.  
  9. Install the cluster and connect the negative battery cable.
  10.  



Click image to see an enlarged view

Fig. Headlight switch P'up, Amigo and Rodeo

 
label.common.footer.alt.autozoneLogo