Isuzu Cars and Trucks 1981-1991

Instrument Cluster

Print

REMOVAL AND INSTALLATION
I-Mark
  1. Disconnect the negative battery cable.
  2.  
  3. Remove the cluster panel (RWD) and cluster hood (FWD).
  4.  
  5. Remove the cluster retaining screws (RWD). Rotate the cluster outward and disconnect the electrical and speedometer cable connectors.
  6.  
  7. Disconnect the wiper switch (FWD).
  8.  
  9. Remove the cluster screws and disconnect the electrical and speedometer connectors (FWD).
  10.  

To install:

  1. Install the cluster and connect the electrical and speedo connectors.
  2.  
  3. Connect the wiper switch (FWD).
  4.  
  5. Install and tighten the cluster retaining screw.
  6.  
  7. Install the cluster trim panel (RWD) and cluster hood (FWD). Connect the battery cable and check operation.
  8.  



Click image to see an enlarged view

Fig. Instrument cluster FWD I-Mark

Impulse and Stylus
  1. Disconnect the negative battery cable.
  2.  
  3. Set the ignition switch to LOCK.
  4.  
  5. Remove the steering wheel and column cover as outlined in this Section (RWD only).
  6.  
  7. Remove the upper cluster hood.
  8.  
  9. Remove the cluster retaining screw, lift cluster out of instrument panel and disconnect the electrical and speedo connectors. Remove the satellite switch assemblies with the cluster (RWD only).
  10.  

To install:

  1. Install the cluster and retaining screws.
  2.  
  3. Install the upper cluster hood.
  4.  
  5. Install the steering wheel and column cover as outlined in this Section (RWD only).
  6.  
  7. Connect the negative battery cable and check operation.
  8.  



Click image to see an enlarged view

Fig. Instrument cluster RWD Impulse



Click image to see an enlarged view

Fig. Instrument cluster RWD Impulse



Click image to see an enlarged view

Fig. Instrument cluster FWD Impulse and Stylus



Click image to see an enlarged view

Fig. Instrument cluster hood FWD Impulse and Stylus

P'up, Amigo, Rodeo and Trooper
  1. Disconnect the negative battery cable.
  2.  
  3. Move the tilt steering wheel to the full down position, if so equipped.
  4.  
  5. Loosen the cluster screws and remove the cluster far enough to disconnect the lighting switch connector.
  6.  
  7. Disconnect the wiper and washer connector from the switch.
  8.  
  9. Remove the cluster from the hood, if needed.
  10.  

To install:

  1. Install the cluster to the hood, if removed.
  2.  
  3. Connect the wiper and washer connector to the switch.
  4.  
  5. Install the cluster and connect the lighting switch connector.
  6.  
  7. Connect the negative battery cable and check operation.
  8.  



Click image to see an enlarged view

Fig. Instrument cluster P'up, Amigo and Rodeo



Click image to see an enlarged view

Fig. Instrument cluster Trooper

 
label.common.footer.alt.autozoneLogo