Isuzu Cars and Trucks 1981-1991

Shifter and Cables

Print

REMOVAL AND INSTALLATION
  1. Disconnect the negative battery cable.
  2.  
  3. Remove the transaxle snap pins from the cable retainers.
  4.  
  5. Remove the cable retaining clips from the cables.
  6.  
  7. Remove the cable nut, and front snap pin.
  8.  
  9. Remove the cable cover, grommet and select cable. Remove the shift cable.
  10.  



Click image to see an enlarged view

Fig. Shifter and cables



Click image to see an enlarged view

Fig. Shifter cable adjustment I-Mark

To install:

  1. Install the cable cover, grommet and select cable. Install the shift cable.
  2.  
  3. Install the cable nut, and front snap pin.
  4.  
  5. Install the cable retaining clips to the cables.
  6.  
  7. Install the transaxle snap pins to the cable retainers.
  8.  
  9. Connect the negative battery cable.
  10.  
  11. Cable Adjustment: make sure the transaxle is in the NEUTRAL position.
  12.  
  13. Turn the adjusting nuts (2) until the change lever (1) is at right angle to the pivot case (3) as viewed from the side of the shifter.
  14.  
  15. After adjustment, tighten the adjusting nuts (2) securely.
  16.  
  17. Turn the adjusting nuts (4) until the change lever (1) is front or rear of the shift control. Tighten the adjusting nuts.
  18.  

FWD Impulse and Stylus
  1. Remove the intercooler, air duct and air cleaner.
  2.  
  3. Remove the snap pins from the cables at the transaxle.
  4.  
  5. Remove the front console panel and console.
  6.  
  7. Remove the shift cable nut, snap pin and adjusting nut.
  8.  
  9. Remove the cable cover and grommet.
  10.  
  11. Pull the cables forward and remove.
  12.  



Click image to see an enlarged view

Fig. Shift cable adjustment Impulse and Stylus

To install:

  1. Push the cables forward and install.
  2.  
  3. Install the cable cover and grommet.
  4.  
  5. Install the shift cable nut, snap pin and adjusting nut.
  6.  
  7. Install the snap pins from the cables at the transaxle.
  8.  
  9. Install the intercooler, air duct and air cleaner.
  10.  
  11. Cable Adjustment: make sure the transaxle is in the NEUTRAL position.
  12.  
  13. Turn the adjusting nuts (2) until the change lever (1) is at right angle to the pivot case (3) as viewed from the side of the shifter.
  14.  
  15. After adjustment, tighten the adjusting nuts (2) securely.
  16.  
  17. Turn the adjusting nuts (4) until the change lever (1) is front or rear of the shift control. Tighten the adjusting nuts.
  18.  
  19. Install the console assembly.
  20.  

 
label.common.footer.alt.autozoneLogo