Isuzu I-280, I-350 2005-06

Removal & Installation

Print

  1. Remove the right hinge pillar trim panel by performing the following:
    1. Remove the right front door sill trim plate.
    2.  
    3. Grasp the right hinge pillar trim panel and gently pull the panel away from the body to release the fasteners.
    4.  
    5. Remove any fasteners that may have pulled away from the panel and reinstall them to the back of the panel.
    6.  
    7. Slide the panel forward so the panel unhooks from around the front door frame.
    8.  
    9. Remove the right hinge pillar trim panel from the vehicle.

      Click image to see an enlarged view

      Fig. Remove the right hinge pillar trim panel

    10.  

  2.  
  3. Remove the blower motor mounting screws.
  4.  
  5. Remove the blower motor cooling tube (2).
  6.  
  7. Disconnect the blower motor electrical connector (4).
  8.  
  9. Remove the blower motor (3).

    Click image to see an enlarged view

    Fig. Removing and in stalling the blower motor

  10.  

To install:

  1. Install the blower motor (3).
  2.  
  3. Connect the blower motor electrical connector (4).
  4.  
  5. Install the blower motor cooling tube (2).
  6.  
  7. Install the blower motor mounting screws. Tighten the screws to 18 inch lbs. (2 Nm).
  8.  
  9. Install the right hinge pillar trim panel.
  10.  

 
label.common.footer.alt.autozoneLogo