Isuzu I-280, I-350 2005-06

Ignition Lock Cylinder

Print

Removal & Installation



  1. Remove the steering column trim covers.
  2.  
  3. Turn the ignition lock cylinder to the Accessory (ACC) position.
  4.  
  5. The lock cylinder access hole is just under the air bag coil on the right center of the column housing.
  6.  
  7. Insert the 90°tip of a pick type tool into the access hole of the ignition lock cylinder.
  8.  
  9. Push down and hold the retaining pin of the ignition lock cylinder.
  10.  
  11. Remove the ignition lock cylinder by pulling the cylinder away from the steering column.
  12.  

To install:

  1. Install the ignition lock cylinder by performing the following procedure:
    1. Turn the ignition lock cylinder to the Accessory (ACC) position.
    2.  
    3. Push the lock cylinder in until the pin locks in the lock module.
    4.  

  2.  
  3. Install the steering column trim covers.
  4.  

 
label.common.footer.alt.autozoneLogo