Isuzu I-280, I-350 2005-06

Ignition Switch

Print

Removal & Installation



  1. Disable the SIR system.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Remove the lower steering column trim cover.
  6.  
  7. Disconnect the ignition switch electrical connector.
  8.  
  9. Turn the ignition lock cylinder to the run position prior to removal of the ignition switch or damage to the components can occur.
  10.  
  11. Remove the two ignition switch screws.
  12.  
  13. Remove the ignition switch.

    Click image to see an enlarged view

    Fig. Removing ignition switch

  14.  

To install:

  1. Install the ignition switch and tighten the two ignition switch screws. Torque to 7 inch lbs. (0.74 Nm).
  2.  
  3. Connect the ignition switch electrical connector.
  4.  
  5. Install the lower steering column trim cover.
  6.  
  7. Re-connect the negative battery cable.
  8.  
  9. Enable the SIR system.
  10.  
  11. Reprogram the theft deterrent system.
  12.  

 
label.common.footer.alt.autozoneLogo