Isuzu I-280, I-350 2005-06

Stabilizer Bar (Sway Bar)

Print

Removal & Installation



  1. Raise and support the vehicle.
  2.  
  3. Support the rear axle at curb height.
    WARNING
    Do not attempt to hold the stabilizer shaft link near the boot. Use the hex feature on the end of the stud. Failure to do so could damage the boot.

  4.  
  5. Remove the stabilizer shaft-to-link nut.
  6.  
  7. Remove the stabilizer shaft insulator bracket mounting bolts.
  8.  
  9. Remove the stabilizer shaft.
  10.  
  11. Remove the stabilizer shaft insulator brackets.
  12.  
  13. Remove the stabilizer shaft insulators.

    Click image to see an enlarged view

    Fig. Rear stabilizer bar bracket



    Click image to see an enlarged view

    Fig. Rear stabilizer bar end link attachment

  14.  

To install:

  1. Install the stabilizer shaft insulators to the stabilizer shaft.
  2.  
  3. Install the stabilizer shaft.
  4.  
  5. Install the stabilizer shaft insulator brackets to the rear axle.
  6.  
  7. Install the stabilizer shaft bracket mounting bolts.
    WARNING
    Do not attempt to hold the stabilizer shaft link near the boot. Use the hex feature on the end of the stud. Failure to do so could damage the boot.

  8.  
  9. Install the stabilizer shaft to link nut. Tighten the stabilizer bar link nut to 32 ft. lbs. (44 Nm). Tighten the insulator bracket bolts to 37 ft. lbs. (50 Nm).
  10.  
  11. Remove the rear axle support.
  12.  
  13. Lower the vehicle.
  14.  

 
label.common.footer.alt.autozoneLogo