Isuzu_Rodeo_Rodeo_Sport_1997-2004

Engine Fan

Print

Removal & Installation



2.2L Engine

On these engines, the engine fan is removed with the radiator assembly. Refer to the Radiator Removal & Installation procedure in this section.

3.2L & 3.5L Engines
  1. Disconnect the negative battery cable.
  2.  
  3. Use a wrench to rotate the belt tensioner to loosen the belt tension, then remove the drive belt.
  4.  
  5. Unfasten the retainers, then remove the fan pulley and fan.
  6.  
  7. Remove the bolts, then remove the fan and clutch assembly.

    Click image to see an enlarged view

    Fig. Drive belt (7) routing-Crankshaft pulley (1), alternator (2), power steering pump (3), water pump and cooling fan pulley (4), idle pulley (5), tension pulley (6)

  8.  

To install:

  1. Install the cooling fan assembly and tighten bolts/nuts to the specified torque, as follows:
    1. Fan pulley and fan bracket: 16 ft. lbs. (22 Nm)
    2.  
    3. Fan and clutch assembly: 66 inch lbs. (7.5 Nm).
    4.  

  2.  
  3. Install the drive belt.
  4.  
  5. Connect the negative battery cable.
  6.  

 
label.common.footer.alt.autozoneLogo