Jeep CJ/Scrambler 1971-1986 Repair Guide

Signal, Parking, Brake and Marker Lights

Print

REMOVAL & INSTALLATION



See Figures 1, 2, 3, 4, 5, 6, 7, 8, 9 and 10

These lights, depending on year and model, can be removed in one of two ways:

  1. Reach up behind the light, disconnect the wire and turn the bulb socket counterclockwise to remove the socket from the lamp.
  2.  
  3. Remove the lamp lens screws, remove the lens, turn the bulb and remove it from the socket.
  4.  



Click image to see an enlarged view

Fig. Fig. 1: To remove the front signal bulb, remove the trim ring screws



Click image to see an enlarged view

Fig. Fig. 2: Pull the signal lens and gasket off of the bulb housing



Click image to see an enlarged view

Fig. Fig. 3: Remove the signal bulb from the socket



Click image to see an enlarged view

Fig. Fig. 4: Remove the front marker light by removing the mounting screws and pulling the assembly out of the fender



Click image to see an enlarged view

Fig. Fig. 5: Pull the marker light bulb from the socket



Click image to see an enlarged view

Fig. Fig. 6: Change any of the rear signal or brake light bulbs by first removing the lens retaining screws and the lens



Click image to see an enlarged view

Fig. Fig. 7: Remove the bulb that is burned out



Click image to see an enlarged view

Fig. Fig. 8: To remove the rear marker light, by first removing the retaining screws and pulling the housing out



Click image to see an enlarged view

Fig. Fig. 9: With the housing removed, the marker light socket can be pulled out



Click image to see an enlarged view

Fig. Fig. 10: Pull the marker light bulb from the socket to replace it

 
label.common.footer.alt.autozoneLogo