Jeep Wagoneer/Commando/Cherokee 1957-1983 Repair Information

Auxiliary Oil Cooler

Print

REMOVAL & INSTALLATION



See Figure 1

Click image to see an enlarged view

Fig. Fig. 1: Auxiliary oil cooler and related components

  1. Remove the attaching screws and lift off the grille panel.
  2.  
  3. Using masking tape, mark the cooler lines for installation.
  4.  
  5. Place a drain pan on the ground, under the cooler.
  6.  
  7. Loosen the clamps securing the hoses to the cooler and slide them out of the way.
  8.  
  9. Twist the hoses to free them from the cooler pipes and slide them off. Cap the hose ends and cooler outlets to prevent dirt from entering.
  10.  
  11. Unbolt and remove the cooler.
  12.  
  13. Installation is the reverse of removal. Add sufficient fluid to refill the system.
  14.  

 
label.common.footer.alt.autozoneLogo