Jeep Wagoneer/Commando/Cherokee 1957-1983 Repair Information

Signal and Marker Lights

Print

See Figures 1 through 5

Click image to see an enlarged view

Fig. Fig. 1: Remove the screws from the marker light lens ...



Click image to see an enlarged view

Fig. Fig. 2: ... then pull the lens forward to expose the electrical connection



Click image to see an enlarged view

Fig. Fig. 3: Pull the bulb from the socket



Click image to see an enlarged view

Fig. Fig. 4: Remove the lens assembly, after removing the tail light lens retaining screws



Click image to see an enlarged view

Fig. Fig. 5: Remove the bulb by turning it counterclockwise

REMOVAL & INSTALLATION Front Parking/Turn Signal Lights



  1. Remove the screws from the lens and separate the lens from the headlight bezel.
  2.  
  3. Remove the headlight bezel.
  4.  
  5. Remove the screws from the turn signal housing and pull it out.
  6.  
  7. Turn the bulb socket counterclockwise 1 / 3 turn and remove it.
  8.  
  9. Installation is the reverse of removal.
  10.  

Side Marker Lights

  1. Remove the screws from the marker lens and separate the lens from the headlight bezel.
  2.  
  3. Pull the bulb from its socket in the back of the lens.
  4.  
  5. Installation is the reverse of removal.
  6.  

Back-Up/Rear Turn Signal/Tail Lights See Figure 6

Click image to see an enlarged view

Fig. Fig. 6: Remove the back-up light lens retaining screws to access the bulb assembly

  1. Remove attaching screws and pull out the tail light assembly.
  2.  
  3. The bulbs can be removed by turning them 1 / 3 turn counterclockwise.
  4.  

Dome Light See Figures 7 and 8

Click image to see an enlarged view

Fig. Fig. 7: Remove the dome lamp lens by squeezing both sides and then pulling it down ...



Click image to see an enlarged view

Fig. Fig. 8: ... then remove the bulb from the housing

Remove the dome lamp lens by squeezing it on both sides. Pull the lens down to gain access to the bulb. If removing the entire assembly, remove the housing retaining clips with a thin blade tool, lower the housing and disconnect the wiring harness.

License Plate Light

WAGONEER/CHEROKEE WITHOUT SWING-OUT SPARE

Remove the two lens screws and remove the bulb hosing from liftgate. Remove bulb from housing.

WAGONEER/CHEROKEE WITH SWING-OUT SPARE

Remove screw holding lens assembly. Pry housing cover from vehicle. Remove bulb.

 
label.common.footer.alt.autozoneLogo