Jeep Wagoneer/Commando/Cherokee 1984-1998

Outside Mirrors

Print

Removal & Installation



Regular

See Figures 1, 2, 3, 4 and 5



Click image to see an enlarged view

Fig. Fig. 1: After removing the interior door panel, remove the side view mirror window trim cover screw



Click image to see an enlarged view

Fig. Fig. 2: Remove the set screw securing the mirror toggle control lever to the trim cover



Click image to see an enlarged view

Fig. Fig. 3: Remove the trim cover and rubber gasket



Click image to see an enlarged view

Fig. Fig. 4: Using a Torx® head bit, remove the 3 side view mirror retaining screws ...



Click image to see an enlarged view

Fig. Fig. 5: ... then pull the side view mirror assembly out of the door

  1. Remove door interior trim panel.
  2.  
  3. Remove the screws holding the window trim cover and remove.
  4.  
  5. If equipped with remote mirror, use a small hex key tool to loosen the set screw which holds the toggle control. Remove the trim cover and gasket.
  6.  
  7. If equipped with power windows, disconnect the wire harness at the connector in the door. Pull the harness up through the door.
  8.  
  9. Remove the mirror retaining screws. Remove the mirror from the door.
  10.  
  11. Installation is the reverse of removal.
  12.  

Wide-View

See Figure 6

  1. Remove the mirror base cover.
  2.  
  3. Remove the mirror base attaching screws. The mirror base reinforcement is attached to the inside of the door with rivets.
  4.  



Click image to see an enlarged view

Fig. Fig. 6: Wide-view exterior mirror

  1. Remove the mirror from the door panel.
  2.  
  3. Installation is the reverse of removal.
  4.  

 
label.common.footer.alt.autozoneLogo