Jeep Wagoneer/Commando/Cherokee 1984-1998

Sunroof

Print

Removal & Installation



  1. Remove the wind deflector mechanism covers.
  2.  
  3. Position the glass to the vent position.
  4.  
  5. Position the sunshade full rearward.
  6.  
  7. Loosen the nuts holding the glass panel to the side adjustment brackets.
  8.  
  9. Slide the glass panel rearward 0.50 in. (12mm) and separate the glass from the sunroof unit.
  10.  

To install:
  1. Position the glass panel in the opening with the logo rearward and slide the panel forward 0.50 in. (12mm).
  2.  
  3. Verify that the attaching nuts are below the top surface of the glass adjustment brackets.
  4.  
  5. Close the sunroof to center the glass in the opening.
  6.  
  7. Tighten the center screws to hold the adjustment.
  8.  
  9. Open the glass to the vent position and tighten the nuts to 71 inch lbs. (8 Nm).
  10.  
  11. Close the glass and check the alignment.
  12.  
  13. Install the mechanism covers.
  14.  
  15. Adjust the wind deflector if necessary.
  16.  

 
label.common.footer.alt.autozoneLogo