Jeep Wagoneer/Commando/Cherokee 1984-1998

Control Cables

Print

Removal & Installation



See Figures 1 and 2

  1. Remove the heater control panel as outlined in this section.
  2.  
  3. Remove the clip and the cable self-adjusting clip from the blend door lever at the bottom of the evaporator/blower housing.
  4.  
  5. Remove the cable by squeezing the tabs with needle nosed pliers, being careful not to break the housing.
  6.  

To install:
  1. Install the cable and attach the clip and self adjusting clip to the blend door lever.
  2.  
  3. Install the heater control panel as outlined in this section.
  4.  



Click image to see an enlarged view

Fig. Fig. 1: Removing the control cable locking tab



Click image to see an enlarged view

Fig. Fig. 2: View of the control cable and ring

 
label.common.footer.alt.autozoneLogo