Jeep Wagoneer/Commando/Cherokee 1984-1998

Ignition Module

Print

Removal & Installation



See Figure 1

  1. Remove the distributor cap and rotor.
  2.  
  3. Disconnect the harness connector and pick-up coil spade connectors from the module. Be careful not to damage the wires when removing the connector.
  4.  
  5. Remove the two screws and module from the distributor housing.
  6.  
  7. Coat the bottom of the new module with dielectric silicone lubricant. This is usually supplied with the new module. Reverse the above procedure to install.
  8.  



Click image to see an enlarged view

Fig. Fig. 1: Ensure the mating surfaces are coated with dielectric compound before installing the module

 
label.common.footer.alt.autozoneLogo