Jeep Wagoneer/Commando/Cherokee 1984-1998

Instrument Cluster

Print

Removal & Installation



See Figures 1 through 12



Click image to see an enlarged view

Fig. Fig. 1: Remove the small plastic instrument panel trim piece from below the steering column by pulling away to disengage the retaining tabs (arrow)



Click image to see an enlarged view

Fig. Fig. 2: Remove the 4 instrument cluster bezel retaining screws



Click image to see an enlarged view

Fig. Fig. 3: Disengage the retaining clips from behind the istrument cluster bezel and pull the bezel away from the dashboard assembly



Click image to see an enlarged view

Fig. Fig. 4: These are the metal clips located behind the instrument cluster bezel



Click image to see an enlarged view

Fig. Fig. 5: Remove the 3 cigar lighter assembly mounting screws



Click image to see an enlarged view

Fig. Fig. 6: After removing the cigar lighter mounting screws, lower the cigar lighter out of the way



Click image to see an enlarged view

Fig. Fig. 7: On the left side of the steering column, remove the rear window defroster switch assembly mounting screw...



Click image to see an enlarged view

Fig. Fig. 8: Remove the instrument cluster assembly retaining screws



Click image to see an enlarged view

Fig. Fig. 9: Pull the instument cluster away from the dash board far enough to disengage the wiring connectors



Click image to see an enlarged view

Fig. Fig. 10: Remove the instrument cluster assembly from the dash board



Click image to see an enlarged view

Fig. Fig. 11: If bulbs in the instrument cluster assembly require replacement, simply turn over the housing to where the sockets are located ...



Click image to see an enlarged view

Fig. Fig. 12: ... then rotate the socket counterclockwise and pull it out

  1. Disconnect the battery ground.
  2.  
  3. Remove the four instrument panel bezel screws and remove the instrument panel bezel. The bezel is a snap fit at several locations.
  4.  
  5. Remove the lighter housing screws.
  6.  
  7. Remove the rear window defroster switch housing screws.
  8.  
  9. Remove the instrument cluster screws.
  10.  
  11. Disconnect the speedometer cable.
  12.  
  13. Pull the cluster part way out and unplug the connectors.
  14.  
  15. Installation is the reverse of removal.
  16.  

 
label.common.footer.alt.autozoneLogo