Jeep Wagoneer/Commando/Cherokee 1984-1998

Power Door Locks

Print

Removal & Installation



Switch
  1. Disconnect the battery ground.
  2.  
  3. Remove the door trim panel and watershield.
  4.  
  5. Remove the switch housing from the inner door panel.
  6.  
  7. Disconnect the wiring and pry up the switch retaining clips. Remove the switch.
  8.  
  9. Installation is the reverse of removal.
  10.  

Actuator Motor

See Figure 1

  1. Disconnect the battery ground.
  2.  
  3. Remove the door trim panel and watershield.
  4.  



Click image to see an enlarged view

Fig. Fig. 1: Power lock actuator

  1. Using a 1 / 4 in. drill bit, drill out the motor mounting rivets.
  2.  
  3. Disconnect the motor actuator rod from the bellcrank.
  4.  
  5. Disconnect the wires from the motor and lift the motor from the door.
  6.  
  7. Installation is the reverse of removal. Use 1 / 4 x 1 / 2 in. bolts and locknuts in place of the rivets.
  8.  

 
label.common.footer.alt.autozoneLogo