Jeep Wagoneer/Commando/Cherokee 1984-1998

Accelerator Sensor

Print

Removal & Installation



See Figure 1

  1. Tilt the rear seat forward to gain access to the sensor.
  2.  
  3. Disengage the sensor harness and unfasten the screws attaching the sensor to the bracket. Remove the sensor from the vehicle.
  4.  

To install:

Note the position of the locating arrow on the sensor. The sensor must be positioned so that the arrow faces forward.

  1. Install the sensor in the bracket and tighten the screws to 17-32 inch lbs. (2-4 Nm).
  2.  
  3. Engage the harness sensor and move the seat back to its normal position.
  4.  



Click image to see an enlarged view

Fig. Fig. 1: Exploded view of the accelerator sensor connections and mounting locations

 
label.common.footer.alt.autozoneLogo