Jeep Wrangler/YJ 1987-1995 Repair Guide

Oil Pump

Print

See Figure 1



Click image to see an enlarged view

Fig. Fig. 1: Oil pump-1992-95 2.5L and 4.0L engines

REMOVAL & INSTALLATION



All Engines

  1. Drain the oil and remove the oil pan as outlined earlier in this section.
  2.  


CAUTION
The EPA warns that prolonged contact with used engine oil may cause a number of skin disorders, including cancer! You should make every effort to minimize your exposure to used engine oil. Protective gloves should be worn when changing the oil. Wash your hands and any other exposed skin areas as soon as possible after exposure to used engine oil. Soap and water, or waterless hand cleaner should be used.

  1. Remove the oil pump retaining screws and separate the oil pump and gasket from the engine block.
  2.  

Do not disturb the position of the oil pick-up tube and screen assembly in the pump body. If the tube is moved within the pump body, a new assembly must be installed to assure an airtight seal.

  1. Installation is the reverse of removal. Torque the short bolts to 10 ft. lbs. (14 Nm) and the long bolts to 17 ft. lbs. (23 Nm).
  2.  

 
label.common.footer.alt.autozoneLogo