Jeep Wrangler/YJ 1987-1995 Repair Guide

Signal, Parking, Brake and Marker Lights

Print

REMOVAL & INSTALLATION



See Figures 1 through 12

Depending on the year and model of your Jeep, these lights can be removed in one of two ways:

  1. Reach up behind the light, disconnect the wire and turn the bulb socket counterclockwise in order to separate the socket from the lamp, or
  2.  
  3. Remove the lamp lens screws, remove the lens, turn the bulb and remove it from the socket.
  4.  



Click image to see an enlarged view

Fig. Fig. 1: Loosen the parking lamp retaining screws using a suitable driver-1992 wrangler shown



Click image to see an enlarged view

Fig. Fig. 2: Make sure all retainers are removed so the lamp housing will be free



Click image to see an enlarged view

Fig. Fig. 3: Pull the parking lamp forward sufficiently for access to the bulb socket at the rear of the lamp



Click image to see an enlarged view

Fig. Fig. 4: Disconnect the bulb socket from the rear of the lamp



Click image to see an enlarged view

Fig. Fig. 5: Remove the bulb from the parking lamp socket



Click image to see an enlarged view

Fig. Fig. 6: Marker lamps are usually removed in the same manner as the parking lamps



Click image to see an enlarged view

Fig. Fig. 7: Once the retainers are removed, pull out the marker lamp sufficiently to access the bulb socket



Click image to see an enlarged view

Fig. Fig. 8: Disconnect the bulb socket from the rear of the lamp



Click image to see an enlarged view

Fig. Fig. 9: Remove the bulb from the marker lamp socket



Click image to see an enlarged view

Fig. Fig. 10: Remove the tail lamp lens retaining screws



Click image to see an enlarged view

Fig. Fig. 11: Remove the tail lamp lens



Click image to see an enlarged view

Fig. Fig. 12: After removing the tail lamp lens the back-up and brake light bulbs may be replaced

 
label.common.footer.alt.autozoneLogo