Log In
Search suggestions

    My Vehicles

    1982 Lincoln Mark VI 5.0L TBI 8cyl

    My Store

    1980 HARLEM AVE
    (708) 442-6770

    CLOSED Open at 7:30 AM

    GET A $25 GIFT CARD FOR EVERY $100 SPENT ON ONLINE SHIP-TO-HOME ORDERS.

    Use Code: GIFTME

    See Details

    Jeep Wrangler/YJ 1987-1995 Repair Guide

    Wiper Motor and Linkage

    Print

    REMOVAL & INSTALLATION



    See Figures 1, 2, 3, 4, 5 and 6



    Click image to see an enlarged view

    Fig. Fig. 1: Wiper motor mounting screws



    Click image to see an enlarged view

    Fig. Fig. 2: Using a suitable prying tool carefully pry off the drive arm



    Click image to see an enlarged view

    Fig. Fig. 3: Wiper motor and drive arm mounting



    Click image to see an enlarged view

    Fig. Fig. 4: Drive arm mounting



    Click image to see an enlarged view

    Fig. Fig. 5: Installing the drive arm on the motor



    Click image to see an enlarged view

    Fig. Fig. 6: Connecting the drive arm to the pivot shaft

    1. Remove the hard or soft top at the windshield frame.
    2.  
    3. Remove the windshield hold-down bolts in the lower corners of the instrument panel.
    4.  
    5. Remove the wiper motor mounting screws.
    6.  
    7. Remove the harness retaining clips located at the bottom of the windshield.
    8.  
    9. Disconnect the wiper linkage drive arm.
    10.  
    11. Grasp the motor and pull the drive arm out of the access hole.
    12.  
    13. Pry the drive arm off of the motor pivot. DO NOT REMOVE THE PIVOT ATTACHING NUT!
    14.  
    15. Remove the 2 screws holding the intermittent wiper module bracket to the bottom of the instrument panel.
    16.  
    17. Reach up behind the instrument panel and disconnect the wiring harness.
    18.  
    19. Remove the motor.
    20.  

    To install:
    1. Install and connect the wiring harness.
    2.  
    3. Install the the intermittent wiper module bracket to the bottom of the instrument panel.
    4.  
    5. Turn the wipers on to make sure the motor cycles to the PARK position.
    6.  
    7. Install the wiper linkage drive arm on the motor pivot.
    8.  
    9. Install the motor and drive arm in the windshield frame.
    10.  
    11. Connect the wiper linkage drive arm to the pivot shaft.
    12.  
    13. Install the wiper motor mounting screws. Torque the screws to 96 inch lbs. (11 Nm).
    14.  
    15. Install the harness retaining clip located at the bottom of the windshield.
    16.  
    17. Install the windshield.
    18.  
    19. Install the hard or soft top at the windshield frame.
    20.  

     
    AutoZone Logo