Kia Amanti 2004-06

Locks & Lock Systems

Print

Power Door Locks



Diagnosis & Testing


Click image to see an enlarged view

Fig. Wiring schematic for driver door lock module

Removal & Installation
Door Lock Motor

The door lock actuator is part of the door lock assembly.

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Remove the power window/door lock switch assembly.
  6.  
  7. Remove door inner handle cover.
  8.  
  9. Remove door trim:

    Remove four door trim screws
     
    Disconnect door trim connector

    Click image to see an enlarged view

    Fig. Door trim screw location

     

  10.  
  11. Remove door screen.
    NOTE
    Peel door screen off carefully so that it can be reused.

  12.  
  13. Remove window glass:
    NOTE
    Remove the glass carefully to avoid brakeage.



    Reconnect power window switch and safety window ECU connector.
     
    Connect negative battery terminal.
     
    Turn ignition switch ON and move window glass grip bolts to opening of access hole.

    Click image to see an enlarged view

    Fig. Access hole for grip bolts

     
    Turn ignition switch OFF
     
    Disconnect negative battery terminal.
     
    Disconnect power window switch and safety window ECU connector.
     
    Remove the two window glass grip bolts.
     



    For installation the torque specification for these bolts is: 72-108 inch lbs. (8-12 Nm).

    Click image to see an enlarged view

    Fig. Window glass grip bolts

     

  14.  
  15. Remove window glass guide:

    Remove window glass guide bolt and nut
     
    For installation the torque specification is: 90-96 inch lbs. (7-11 Nm).
     

  16.  
  17. Remove door speaker:

    Remove the four door speaker screws
     
    Disconnect door speaker electrical connector
     

  18.  
  19. Remove door module assembly:

    Disconnect the two inner handle cables
     
    Disconnect door module connector
     
    Remove wire harness from door module assembly
     
    Remove the three door module bolts and nuts. Tightening torque for installation: 61-96 inch lbs. (7-11 Nm).
     
    Separate door module from door latch assembly by pushing stopper with a screwdriver and then pull the door module toward the door latch to remove it.
     

  20.  
  21. Remove door latch:

    )Disconnect the two outer handle rods
     
    Remove the three door latch screws.
     
    Disconnect door latch actuator connector.
     

  22.  
  23. Remove outer handle:

    )Remove the two outer handle bolts
     
    Remove key cylinder
     
    Remove outer handle base
     
    Remove outer handle
     

  24.  
  25. Remove door lock motor.
  26.  

To install:

  1. Installation is the reverse of the removal procedure.
  2.  
  3. When installing each rod, be sure to rotate the rod holder until a click is felt.

    Click image to see an enlarged view

    Fig. Front door components

  4.  

Door Lock Switch
  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Carefully pry upward on the switch assembly.
  6.  
  7. Disconnect the electrical connectors from the switch assembly.
  8.  
  9. Remove the switch assembly.
  10.  

To install:

  1. Installation is the reverse of the removal procedure.
  2.  

 
label.common.footer.alt.autozoneLogo