Removal & Installation
Disconnect the negative battery cable.
Remove the steering wheel and combination and/or multi-function switch, as outlined in this section.
Remove the attaching bolts and the steering wheel upper column.
Detach the ignition switch electrical connector.
Use a chisel to make a groove in the head of the ignition switch bolts.
Remove the bolts with a screwdriver, then remove the ignition switch.
Fig. Remove the bolts, then remove the steering upper column
Fig. Ignition switch removal
Installation is the reverse of the removal procedure. After installing the ignition switch on the jacket, install new ignition switch bolt and tighten them until the heads break off.