LaCrosse 2006-2007

Multi-Function (Combination) Switch

Print

Removal & Installataion



  1. Disable the SIR system for zone 3.
  2.  
  3. Remove the upper and lower trim covers.
    NOTE
    The abrasion sleeve located on the steering column wire harness assembly must be reinstalled. Make note of what connector is coming out of the abrasion sleeve for installation purposes.

  4.  
  5. Remove the wire harness assembly from the wire harness strap.
  6.  
  7. Disconnect the turn signal and multifunction switch assembly connector from the SIR system coil connector.
  8.  
  9. Slide the 2 connectors of the turn signal and multifunction switch assembly out of the bulkhead connector.
  10.  
  11. Remove the 2 pan head tapping screws and from the turn signal and multifunction switch assembly.
  12.  
  13. Remove the turn signal and multifunction switch assembly from the steering column tilt head assembly.
  14.  

To install:

  1. Install the turn signal and multifunction switch assembly onto the steering column tilt head assembly.
  2.  
  3. Be sure that the electrical contact of the turn signal and multifunction switch assembly rests on the turn signal cancel cam assembly.
  4.  
  5. Screw the 2 pan head tapping screws and into the turn signal and multifunction assembly.
  6.  
  7. Tighten the top pan head tapping screw to 27 inch lbs. (3 Nm), and the side pan head tapping screw  to 62 inch lbs. (7 Nm).
  8.  
  9. Slide the 2 connectors of the turn signal and multifunction switch assembly into the bulkhead connector.
  10.  
  11. Connect the turn signal and multifunction switch assembly connector to the SIR coil connector.
  12.  
  13. The abrasion sleeve must be installed back onto the steering column wire harness assembly. The ignition lock cylinder case wires and connector must be hanging out of the middle of the abrasion sleeve.
  14.  
  15. Install the wire harness assembly into the wire harness strap.
  16.  
  17. Install the upper and lower trim covers.
  18.  
  19. Enable the SIR system
  20.  

 
label.common.footer.alt.autozoneLogo