Land Rover 2000-05

Pipe Disconnect

Print

  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. If it is necessary to disconnect a pipe:
    1. Wear hand, ear and eye protection. Wrap a cloth around the connection.
    2.  
    3. Clean the connection with a stiff wire brush.
    4.  
    5. Peel back the boot.
    6.  
    7. Apply equal downward pressure on the collet flange (A) as shown.
    8.  


      Click image to see an enlarged view

      Fig. Air pipe disconnection

    9. Pull the pipe firmly through the center of the collet.
    10.  
    11. To connect the pipe, push it firmly through the 2 O-rings until it contacts the base of the housing. Gently pull back on the pipe. Some slight movement will be noticed.
    12.  
    13. Reposition the boot.
    14.  

  4.  

When the job is done, run the engine to repressurize the system. The system must be recalibrated using the TestBook tool. Recalibration must be done on a floor surface that is level and smooth in all directions.

Before servicing the vehicle, refer to the precautions in the beginning of this section.

If it is necessary to disconnect a pipe:

  1. Wear hand, ear and eye protection. Wrap a cloth around the connection.
  2.  
  3. Clean the connection with a stiff wire brush.
  4.  
  5. Peel back the boot.
  6.  
  7. Apply equal downward pressure on the collet flange at -A-, as shown.

    Click image to see an enlarged view

    Fig. Air pipe disconnection

  8.  
  9. Pull the pipe firmly through the center of the collet.
  10.  
  11. To connect the pipe, push it firmly through the 2 O-rings until it contacts the base of the housing. Gently pull back on the pipe. Some slight movement will be noticed.
  12.  
  13. Reposition the boot.
  14.  

When the job is done, run the engine to repressurize the system. The system must be recalibrated using the TestBook tool. Recalibration must be done on a floor surface that is level and smooth in all directions.

 
label.common.footer.alt.autozoneLogo