Land Rover 2000-05

Removal & Installation

Print

  1. To remove the driver temperature control and air flow control cables, release fixings and lower fascia fuse box access cover.
  2.  
  3. To remove the passenger temperature control cable, remove 4 screws securing glove box, release catch and remove glove box.
  4.  
  5. Remove louver panel assembly.
  6.  
  7. Release control cable abutment from control housing and disconnect inner cable from control.
  8.  
  9. Release clip securing control outer cable to heater case and disconnect inner cable from flap lever.
  10.  
  11. Remove control cable.
  12.  

To install:

  1. Fit new control cable, connect inner cable to control and secure abutment to control housing.
  2.  
  3. Fit other end of inner cable to flap lever.
  4.  
  5. Position control to maximum heat for temperature control cables or demist for air flow control cable, hold flap lever in fully closed position and secure outer cable in clip on heater casing.
  6.  
  7. Refit louver panel assembly.
  8.  
  9. Driver temperature and air flow control cables: Close fuse access cover and secure fixings.
  10.  
  11. Passenger temperature control cable: Refit glove box and secure with bolts.
  12.  

 
label.common.footer.alt.autozoneLogo