Land Rover 2000-05

Ignition Coils

Print

Removal & Installation



  1. Disconnect the negative battery cable.
  2.  
  3. Remove the upper inlet manifold gasket
  4.  
  5. Unfasten the 2 lower coil mounting bolts.
  6.  
  7. Disconnect the multiplugs from coils.

    Click image to see an enlarged view

    Fig. Unfasten the lower coil bolts (2) and detach the multiplugs from the coils (3)

  8.  
  9. Remove the spark plug wires from the rocker covers and tag and detach the spark plug wires from the plugs.

    Click image to see an enlarged view

    Fig. Remove the spark plug wires from the rocker covers and tag and detach the spark plug wires from the plugs

  10.  
  11. Carefully maneuver the coil assembly from between engine and bulkhead and remove.
  12.  

To install:

  1. Position the ignition coil to bracket and secure with the screws.
  2.  
  3. Connect the wires to terminals and secure with nuts.
  4.  
  5. Install the terminal cover.
  6.  
  7. Position the ignition coil bracket on inlet manifold studs.
  8.  
  9. Secure the fuel rail and ignition coil bracket with nuts and tighten to 6 ft. lbs. (8 Nm).
  10.  
  11. Connect the multiplugs.
  12.  
  13. Connect the spark plug wires to the plugs and coils, as tagged during removal.
  14.  
  15. Connect the negative battery cable.
  16.  

  1. Remove engine acoustic cover.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Remove LH ignition coil cover.
  6.  
  7. Remove RH ignition coil cover.
  8.  
  9. Remove 2 nuts and disconnect the ground leads from camshaft covers.
  10.  
  11. Disconnect multiplugs from ignition coils.
  12.  
  13. Discard ignition coil cover gasket.
  14.  
  15. Remove the 14 ignition coil securing nuts, then remove 8 ignition coils.

    Click image to see an enlarged view

    Fig. Exploded view of the ignition coil mounting

  16.  

To install:

  1. Install the 8 ignition coils and secure with the 14 retaining nuts. Tighten the nuts to 3 ft. lbs. (4 Nm).
  2.  
  3. Install a new ignition coil cover gasket.
  4.  
  5. Connect multiplugs to ignition coils.
  6.  
  7. Connect the ground lead to camshaft cover and tighten the nut to 3 ft. lbs. (4 Nm).
  8.  
  9. Install the right and left ignition coil covers.
  10.  
  11. Install the engine acoustic cover.
  12.  
  13. Connect the negative battery cable.
  14.  

 
label.common.footer.alt.autozoneLogo