Land Rover 2000-05

Crankshaft Damper (Balancer)

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Remove or disconnect the following:

    Battery ground cable
     
    Cooling fan
     
    Water pump pulley bolts
     
    Drive belt
     
    Engine under-cover
     

  4.  
  5. Install a holding tool, such as LRT-12-080, on the pulley
  6.  
  7. Remove the pulley bolt and pulley.

    Click image to see an enlarged view

    Fig. Crankshaft pulley holding tool

  8.  

To install:

  1. Install the holding tool, position the pulley on the crankshaft and install the bolt. Torque the bolt to 200 ft. lbs. (270 Nm).
  2.  
  3. The remainder of installation is the reverse of removal.
  4.  

  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Remove auxiliary drive belt.
  4.  
  5. Remove oil pan.
  6.  
  7. Remove 2 bolts and 1 nut and remove oil pickup strainer.
  8.  
  9. Remove and discard 3 water pump pulley bolts. Remove the pulley.
  10.  
  11. Use a tool, LRT-12-080, to hold crankshaft pulley, then remove the pulley bolt and pulley.
  12.  

To install:

  1. Clean and install crankshaft pulley. Tighten bolt to 200 ft. lbs. (270 Nm).
  2.  
  3. Clean oil filter mating face and install a new oil seal after coating filter seal with clean engine oil.
  4.  
  5. Clean water pump and pulley mating faces. Remove all traces of thread locking material from water pump pulley drive flange bolt holes.
  6.  
  7. Install water pump pulley and tighten new Patchlok bolts to 16 ft. lbs. (22 Nm).
  8.  
  9. Install oil pickup strainer as follows:
    1. Clean oil pickup strainer and O-ring recess.
    2.  
    3. Lubricate and install a new O-ring.
    4.  
    5. Locate washer on stud and position oil pickup strainer.
    6.  
    7. Install and tighten bolts to 8 ft. lbs. (10 Nm).
    8.  
    9. Install and tighten nut to 16 ft. lbs. (22 Nm).
    10.  

  10.  
  11. Install oil pan with new gasket.
  12.  
  13. Install auxiliary drive belt.
  14.  

  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Remove or disconnect the following:

    Battery ground cable
     
    Cooling fan
     
    Ancillary drive belt
     
    A/C compressor drive belt
     
    Crankshaft pulley
     

  4.  

To install:

  1. Install or connect the following:

    Crankshaft pulley to hub
     
    Crankshaft pulley bolts and tighten to 16 ft. lbs. (22 Nm).
     
    A/C compressor drive belt
     
    Ancillary drive belt
     
    Cooling fan
     
    Battery ground cable
     

  2.  

 
label.common.footer.alt.autozoneLogo