Lexus Car ES, IS, LS 1998-06

Slave (Actuator) Cylinder

Print

Removal & Installation





Click image to see an enlarged view

Fig. Exploded view of the slave cylinder (clutch release cylinder)-IS 300

  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Disconnect the negative battery cable. Wait at least 90 seconds before performing any other work.
  4.  
  5. Using SST 09023-00100, disconnect the clutch line. Use a container to catch the fluid.
  6.  
  7. Remove the 2 bolts and pull out the clutch release cylinder.
  8.  

To install:

  1. Install the clutch release cylinder and the 2 bolts. Tighten the bolts to 9 ft. lbs. (12 Nm).
  2.  
  3. Connect the clutch line. Tighten the clutch line fitting to 11 ft. lbs. (15.2 Nm).
  4.  
  5. Connect the negative battery cable.
  6.  



Click image to see an enlarged view

Fig. Exploded view of the slave cylinder (clutch release cylinder)-IS 250

  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Disconnect the negative battery cable. Wait at least 90 seconds before performing any other work.
  4.  
  5. Remove the 3 bolts and separate the clutch accumulator assembly.
  6.  
  7. Using SST 09023-00101, disconnect the clutch line. Use a container to catch the fluid.
  8.  
  9. Remove the 2 bolts and clutch release cylinder.
  10.  

To install:

  1. Temporarily tighten the clutch release cylinder with the 2 bolts.
  2.  
  3. Temporarily tighten the clutch accumulator with the 3 bolts.
  4.  
  5. Using SST 09023-00101, connect the clutch line. Tighten the fitting to 11 ft. lbs. (15 Nm). Use a torque wrench with a fulcrum length of 11.81 inches (300mm).
  6.  
  7. Fully tighten the clutch release cylinder with the 2 bolts to 9 ft. lbs. (12 Nm).
  8.  
  9. Fully tighten the clutch accumulator with the 3 bolts to 9 ft. lbs. (12 Nm).
  10.  
  11. Fill the brake reservoir with the brake fluid and bleed the clutch system.
  12.  
  13. Check for leakage in the clutch system.
  14.  
  15. Inspect the fluid level.
  16.  
  17. Connect the negative battery cable.
  18.  

 
label.common.footer.alt.autozoneLogo