Lexus RX300, 330 3 2000-06

Crankshaft Damper (Balancer)

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the precautions section.
  2.  
  3. Remove or disconnect the following:
    NOTE
    To extract the engine bracket and control rod, raise the engine slightly.



    Engine coolant reservoir tank and the alternator belt
     
    Right front wheel and the splash shield
     
    Power steering pump drive belt, by loosening both bolts
     
    Both ground wire connectors
     
    Right engine mounting stay
     
    Engine moving control rod and the No. 2 right engine mount bracket
     



    No. 2 alternator bracket
     
    Crankshaft pulley bolt, using a prybar and wrench or Crankshaft Pulley Holding tool 09213-54015 and Flange Holding tool 09330-00021
     
    Crankshaft pulley, using a puller
     

  4.  

To install:

  1. Install or connect the following:

    Crankshaft pulley. Tighten the bolt to 159 ft. lbs. (215 Nm).
     
    No. 2 alternator bracket. Tighten the nut to 21 ft. lbs. (28 Nm). Do not tighten the pivot bolt at this time.
     
    No. 2 right engine mounting bracket and the moving control rod
     
    Right engine mount stay
     
    Both ground wire connectors
     
    Drive belts by adjusting them
     
    Coolant reservoir
     
    Right front splash shield and wheel
     
    Negative battery cable
     

  2.  
  3. Start the vehicle and check for any leaks.
  4.  
  5. Recheck the ignition timing.
  6.  

  1. Before servicing the vehicle, refer to the precautions section.
  2.  
  3. Remove or disconnect the following:
    NOTE
    To extract the engine bracket and control rod, raise the engine slightly.



    Engine coolant reservoir tank and the alternator belt
     
    Right front wheel and the splash shield
     
    Power steering pump drive belt, by loosening both bolts
     
    Both ground wire connectors
     
    Right engine mounting stay
     
    Engine moving control rod and the No. 2 right engine mount bracket
     



    No. 2 alternator bracket
     
    Crankshaft pulley bolt, using a prybar and wrench or Crankshaft Pulley Holding tool 09213-54015 and Flange Holding tool 09330-00021
     
    Crankshaft pulley, using a puller
     

  4.  

To install:

  1. Install or connect the following:

    Crankshaft pulley. Tighten the bolt to 162 ft. lbs. (219 Nm).
     
    No. 2 alternator bracket. Tighten the nut to 21 ft. lbs. (28 Nm). Do not tighten the pivot bolt at this time.
     
    No. 2 right engine mounting bracket and the moving control rod
     
    Right engine mount stay
     
    Both ground wire connectors
     
    Drive belts by adjusting them
     
    Coolant reservoir
     
    Right front splash shield and wheel
     
    Negative battery cable
     

  2.  
  3. Start the vehicle and check for any leaks.
  4.  
  5. Recheck the ignition timing.
  6.  

 
label.common.footer.alt.autozoneLogo