Lexus RX300, 330 3 2000-06

Outside Mirrors

Print

Power Mirrors



Removal & Installation
Motor
  1. Disconnect the negative battery cable.
  2.  
  3. Remove power window regulator/door lock master switch as follows:
    1. Using a suitable prytool (or a screwdriver with its tip taped to prevent damage), carefully disengage the hook, remove the power window regulator master switch.
    2.  
    3. Disconnect the electrical connector.

      Click image to see an enlarged view

      Fig. Using a suitable prytool (or a screwdriver with it-s tip taped to prevent damage), carefully disengage the hook, remove the power window regulator master switch

    4.  

  4.  
  5. Using a suitable prytool (or a screwdriver with its tip taped to prevent damage), carefully disengage the hook, remove the front door lower frame bracket garnish.

    Click image to see an enlarged view

    Fig. Using a suitable prytool (or a screwdriver with it-s tip taped to prevent damage), carefully disengage the hood, remove the front door lower frame bracket garnish

  6.  
  7. Using a suitable prytool (or a screwdriver with its tip taped to prevent damage), disengage the hook, remove the door pull handle.

    Click image to see an enlarged view

    Fig. Disengage the hook with a prytool, then remove the door pull handle

  8.  
  9. Remove front door trim panel, as follows:
    1. Remove the screw.
    2.  
    3. Using a prytool or taped screwdriver, disengage the hook, then remove the door inside handle bezel.
    4.  
    5. Remove the clip and screw.
    6.  
    7. Using a prytool or screwdriver with it-s end taped to prevent damage, disengage the hook, remove the front door trim panel.

      Click image to see an enlarged view

      Fig. Remove the screw. Then, using a prytool or taped screwdriver, disengage the hook, then remove the door inside handle bezel



      Click image to see an enlarged view

      Fig. Location of the front door trim panel retaining hooks

    8.  

  10.  
  11. If necessary, remove the service hole cover.
  12.  
  13. Remove the side rear view mirror, as follows:
    1. Remove the 3 bolts.
    2.  
    3. Disconnect the connector then remove the side rear view mirror.
    4.  

  14.  

To install:

  1. Installation is the reverse of the removal procedure, but note the following important steps.
  2.  
  3. Install a new service hole cover to the door panel.
    NOTE
    When installing the service hole cover, pull out the links and connectors through the service hole cover. There should be no wrinkles or folds after installing the service hole cover. After installing the service hole cover, check the sealing condition.

  4.  

 
label.common.footer.alt.autozoneLogo