Lexus RX400h, Hybrid 3 2006
Removal & Installation
Remove the wheel.
Remove the speed sensor from the axle carrier.
Remove the axle shaft nut.
Remove the caliper and support assembly and suspend it out of the way.
Check the bearing backlash. It should not exceed 0.0020 in. (0.05mm). If it does, it must be replaced.
Remove the 4 bolts and remove the hub/bearing assembly.
Installation is the reverse of removal. Observe the following torques:
Hub/bearing assembly bolts: 55 ft. lbs. (75 Nm)
Caliper support: 58 ft. lbs. (78 Nm)
Brake hose clamp: 14 ft. lbs. (19 Nm)
Hub nut: 217 ft. lbs. (294 Nm)