Removal & Installation
- Before servicing the vehicle, refer to the Precautions section.
Remove or disconnect the following:
The weight of the vehicle must be supported by the springs when the control arm and track bar fasteners are tightened.
Install or connect the following:
Axle housing and coil springs to the vehicle
- Tighten the upper control arm nuts to 55 ft. lbs. (75 Nm), the lower control arm nuts to 85 ft. lbs. (115 Nm) and the track bar bolts to 74 ft. lbs. (100 Nm).
- Check the wheel alignment and adjust as necessary.