Liberty, Wrangler 2006-2007

Mirrors

Print

Power Mirrors



Diagnosis & Testing

Any diagnosis of the Power Mirror system should begin with the use of scan tool. For information on the use of the scan tool, refer to the appropriate Diagnostic Service information.


NOTE
For complete circuit diagrams, refer to the appropriate wiring information.

  1. Check the fuses in the Power Distribution Center (PDC) and the junction block. If OK, go to Step 2. If not OK, repair the shorted circuit or component as required and replace the faulty fuse(s).
  2.  
  3. Check for battery voltage at the fuse in the junction block. If OK, go to Step 3. If not OK, repair the open circuit to the PDC as required.
  4.  
  5. Disconnect and isolate the battery negative cable. Remove the driver side power window switch and bezel assembly and unplug the wire harness connector from the power mirror switch. Connect the battery negative cable. Check for battery voltage at the fused B(+) circuit cavity in the door wire harness half of the power mirror switch wire harness connector. If OK, go to Step 4. If not OK, repair the open circuit to the junction block as required.
  6.  
  7. Disconnect and isolate the battery negative cable. Check for continuity between the ground circuit cavity in the door wire harness half of the power mirror switch wire harness connector and a good ground. There should be continuity. If not OK, repair open in the ground circuit.
  8.  

Removal & Installation
Motor
  1. Partially remove the door trim panel as necessary to gain access to the mirror.
  2.  
  3. Disconnect the electrical connector.
  4.  
  5. Remove the three nuts and remove the mirror assembly.

    Click image to see an enlarged view

    Fig. Power mirror mounting

  6.  

Switch
  1. Disconnect and isolate the battery negative cable.
  2.  
  3. Remove the inside handle screw plug and remove the screw.
  4.  
  5. Remove the pull handle screw.
  6.  
  7. Using a trim stick C-4755 or equivalent, disengage the trim panel clips and remove the trim panel.
  8.  
  9. Disconnect wire harness connector from switch.
  10.  
  11. Remove switch from door trim panel.
  12.  
  13. Installation is the reverse of removal.
  14.  

 
label.common.footer.alt.autozoneLogo