Liberty, Wrangler 2006-2007

Removal & Installation

Print

The fuel level sending unit (fuel level sensor) and float assembly is located on the side of fuel pump module. The fuel pump module is located within the fuel tank.

  1. Remove fuel tank.
  2.  
  3. Remove fuel pump module.
  4.  
  5. Remove electrical wire connector at sending unit terminals.
  6.  
  7. Press on release tab to remove sending unit from pump module.
  8.  

To install:

  1. Position sending unit to pump module and snap into place.
  2.  
  3. Connect electrical connector to terminals.
  4.  
  5. Install fuel pump module.
  6.  
  7. Install fuel tank.
  8.  

The fuel level sending unit (fuel level sensor) and float assembly is located on the side of the lower section of the fuel pump module. The lower section of the fuel pump module is located within the fuel tank.

  1. Remove lower section of fuel pump module from fuel tank.
  2.  
  3. To remove sending unit from pump module, lift on plastic locking tab while sliding sending unit upwards.
  4.  
  5. Disconnect 4-wire electrical connector from bottom of upper section of fuel pump module. Separate necessary sending unit wiring.
  6.  

To install:

  1. Connect necessary wiring into electrical connectors. Connect 4-wire connector to upper section of pump module.
  2.  
  3. Position sending unit to pump module. Slide and snap into place.
  4.  
  5. Install lower section of fuel pump module.
  6.  

 
label.common.footer.alt.autozoneLogo