Log In
Search suggestions

    My Vehicles

    Add a Vehicle

    Find a Store

    Select Store

    GET A $25 GIFT CARD FOR EVERY $100 SPENT ON ONLINE SHIP-TO-HOME ORDERS.

    Use Code: GIFTME

    See Details

    Liberty, Wrangler 2006-2007

    Testing

    Print

    The fuel gauge sending unit (fuel level sensor) is attached to the side of the fuel pump module. The sending unit consists of a float, an arm, and a variable resistor track. The resistor track is used to send electrical signals to the PCM for fuel gauge and for OBD II emission requirements.

    As fuel level increases the float and arm move up. This decreases the sending unit resistance, causing the fuel gauge to move towards "F". As fuel level decreases, the float and arm move down, and the gauge moves to "E".

    When this signal is sent to the PCM, the PCM will transmit the data across the CCD bus circuits to the instrument panel. Here it is translated to an appropriate fuel gauge level reading.

    For OBD II emission monitor requirements, a voltage signal is sent from the resistor track on the sending unit to the PCM to indicate fuel level. The purpose of this feature is to prevent the OBD II from recording/setting false misfire and fuel system monitor trouble codes. The feature is activated if the level in the tank is less than approximately 15 percent of its rated capacity. If equipped with a leak detection pump, this feature will also be activated if the fuel level in the tank is more than about 85 percent of its rated capacity.

    1. Measure the resistance across the sending unit terminals.
    2.  
    3. With the float in the "up" position, resistance should be 14-26 ohms.
    4.  
    5. With the float in the "down" position, resistance should be 214-226 ohms.
    6.  
    7. Resistance should increase and decrease gradually as the float arm is moved. If odd resistance readings are evident at any point in the movement, replace the sending unit.
    8.  

     
    AutoZone Logo