Liberty, Wrangler 2006-2007

Window Systems

Print

Power Window System



Diagnosis & Testing

Any diagnosis of the Power Windows system should begin with the use of scan tool. For information on the use of the scan tool, refer to the appropriate Diagnostic Service information.

  1. Turn the ignition on.
  2.  
  3. With the scan tool, record and erase DTC's.
  4.  
  5. Turn the ignition off, wait 10 seconds then turn the ignition on.
  6.  
  7. Try to operate the window several times.
  8.  
  9. With the scan tool, read active DTC's.
  10.  
  11. On the scan tool, refer to the symptom list for problems related to the power window DTC's.
  12.  

Removal & Installation
Switch
Front Door
  1. Disconnect and isolate the battery negative cable.
  2.  
  3. Remove the shift bezel.
  4.  
  5. Remove the mounting fasteners and switch.
  6.  
  7. Disconnect electrical harness connector.
  8.  
  9. Installation is the reverse of removal.
  10.  

Rear Door
  1. Disconnect and isolate the battery negative cable.
  2.  
  3. Using a trim stick, gently pry the switch from the console.
  4.  
  5. Disconnect electrical harness connector.
  6.  
  7. Installation is the reverse of removal.
  8.  

Window Motor & Regulator
  1. Disconnect and isolate the battery negative cable.
  2.  
  3. Remove the inside handle screw plug and remove the screw.
  4.  
  5. Remove the pull handle screw.
  6.  
  7. Using a trim stick C-4755 or equivalent, disengage the trim panel clips and remove the trim panel.
  8.  
  9. Disconnect the electrical connectors and the inside handle actuator rod.
  10.  
  11. Remove the waterdam as necessary to gain access to the regulator.
  12.  
  13. Raise the glass to the position shown and using a long flat blade or hook type tool, disengage clips attaching glass retainer to regulator lift plate.
  14.  
  15. Disconnect the glass from the regulator lift plate and re-install the clips.
  16.  
  17. Secure the glass in the up position using a wood wedge, tape or equivalent.
  18.  
  19. Loosen the bolts.
  20.  
  21. Disconnect the runout tube clip.
  22.  
  23. Disconnect the electrical connector and remove the regulator.
  24.  
  25. Installation is the reverse of removal.

    Click image to see an enlarged view

    Fig. Front door regulator mounting



    Click image to see an enlarged view

    Fig. Rear door regulator mounting

  26.  

 
label.common.footer.alt.autozoneLogo