Liberty, Wrangler 2006-2007

Windshield Wiper Systems

Print

Removal & Installation



Wiper Motor
  1. Remove the front wiper arms from the wiper pivots.
  2.  
  3. Unlatch, open and support the hood.
  4.  
  5. Disconnect and isolate the battery negative cable.
  6.  
  7. Remove the cowl plenum cover/grille panel from over the cowl plenum.
  8.  
  9. Disconnect the body wire harness connector for the front wiper motor from the motor pigtail wire connector.
  10.  
  11. Remove the three screws that secure the front wiper module mounting bracket to the cowl plenum panel.
  12.  
  13. Remove the front wiper module from the cowl plenum panel as a unit.
  14.  
  15. Installation is the reverse of removal. Tighten the mounting bolts to 105 inch lbs. (12 Nm).
  16.  



Click image to see an enlarged view

Fig. Exploded view of the wiper module on the Liberty

  1. Unlatch and open the hood.
  2.  
  3. Disconnect and isolate the battery negative cable.
  4.  
  5. Remove both front wiper arms from the wiper pivots.
  6.  
  7. Remove the cowl plenum cover/grille panel from over the cowl plenum.
  8.  
  9. Disconnect the headlamp and dash wire harness connector for the front wiper motor from the motor pigtail wire connector.
  10.  
  11. Remove the two screws that secure the front wiper module to the top of the cowl plenum panel at the pivot brackets.
  12.  
  13. Remove the two nuts that secure the front wiper module to the two weld studs on the bottom of the cowl plenum panel.
  14.  
  15. Lift the front wiper module up from the cowl plenum panel far enough to disengage the two lower insulators from the weld studs on the bottom of the plenum panel.
  16.  
  17. Remove the front wiper module from the cowl plenum panel as a unit.
  18.  
  19. Installation is the reverse of removal.
  20.  

 
label.common.footer.alt.autozoneLogo