Lincoln Blackwood, Ford F-Series Pick-ups, Lincoln Mark LT 2001-2006



Removal & Installation

Click image to see an enlarged view

Fig. 1. ABS module electrical connector 2. Hydraulic control unit (HCU) electrical connector 3. ABS module screws 4. ABS module ABS system module-F-150 and Mark LT

Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.

Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.

Electronic modules are sensitive to electrical charges. The ABS module can be damaged if exposed to these charges.

When installing a new ABS module or hydraulic control unit (HCU), do not use the pump motor harness as a carrying handle. Failure to follow these instructions may result in damage to the HCU assembly.

  1. Disconnect the battery.
  3. Remove the air cleaner assembly.
  5. Disconnect the ABS module electrical connector.
  7. Remove the 6 screws and the ABS module. Disconnect the HCU electrical connector.
    The ABS module is not repairable. If an internal problem exists, a new part must be installed.

  9. To install, reverse the removal procedure. Tighten the screws in the sequence shown to 3 Nm (27 inch lbs.).

    Click image to see an enlarged view

    Fig. ABS module fastener torque sequence-F-150 and Mark LT

  11. When installing a new ABS module, it must be configured (using vehicle as-built data) and calibrated. Follow the diagnostic tool directions for calibration procedures.