Maxima 2007

Hydraulic Control Module

Print

Removal & Installation



  1. Disconnect battery negative terminal.
  2.  
  3. Remove windshield wiper and linkage assembly.
  4.  
  5. Drain brake fluid.
  6.  
  7. Discharge the A/C refrigerant for Maxima.
  8.  
  9. Disconnect and remove high-pressure and low-pressure A/C pipes to allow access to ABS actuator and electric unit (control unit) for Maxima.
  10.  
  11. Disconnect harness connectors from ABS actuator and electric unit (control unit).
  12.  
  13. Disconnect brake pipes, noting their location for installation.
  14.  
  15. Remove bolts and ABS actuator and electric unit (control unit).
  16.  

To install:

  1. Position ABS actuator and electric unit (control unit) in vehicle.
  2.  
  3. Connect brake pipes and bolts temporarily.
  4.  
  5. Tighten bolts and brake pipes to specification.
  6.  
  7. Connect ABS actuator and electric unit (control unit) harness connectors.
  8.  
  9. Install and connect high-pressure and low-pressure A/C pipes.
  10.  
  11. Install windshield wiper and linkage assembly.
  12.  
  13. Connect battery negative terminal.
  14.  
  15. Evacuate and recharge the A/C system.
  16.  
  17. Adjust the steering angle sensor.
  18.  

 
label.common.footer.alt.autozoneLogo