Maxima 2007

Master Cylinder

Print

Removal & Installation



  1. Remove kicking plate.
  2.  
  3. Remove footrest.
  4.  
  5. Remove dash side finisher.
  6.  
  7. Remove instrument driver panel lower.
  8.  
  9. Remove snap pin and clevis pin from the clevis, and separate it from clutch pedal.
  10.  
  11. Remove hood ledge cover.
  12.  
  13. Drain clutch fluid in reservoir tank and then remove reservoir hose.
  14.  
  15. Remove reservoir tank mounting nut and then remove reservoir tank.
  16.  
  17. Remove clutch tube using a flare nut wrench.
  18.  
  19. Remove mounting nuts and then remove packing and master cylinder assembly.
  20.  

To install:

  1. Check position of clevis and push rod. If measurement is outside the standard length, adjust position of clevis and push rod. Standard length 4.37 in. plus or minus 0.02 in.
  2.  
  3. Install packing and master cylinder assembly and tighten mounting nuts.
  4.  
  5. Connect clutch tube to master cylinder assembly and temporarily tighten flare nut.
  6.  
  7. Tighten clutch tube flare nut.
  8.  
  9. Install clevis to the clutch pedal, and fix clevis with clevis pin.
  10.  
  11. Install snap pin to the clevis pin.
  12.  
  13. Install reservoir hose to the nipple. Install the reservoir tank to the vehicle, and then tighten mounting nuts to the specified torque.
  14.  
  15. After completing this procedure, inspect and adjust for clutch pedal and then bleed the clutch hydraulic system.
  16.  
  17. Install hood ledge cover.
  18.  
  19. Install instrument driver panel lower.
  20.  
  21. Install dash side finisher.
  22.  
  23. Install footrest.
  24.  
  25. Install kicking plate.
  26.  

 
label.common.footer.alt.autozoneLogo