Maxima 2007

Sunroof

Print

Power Sunroof



Diagnosis & Testing
Motor

Specific to:

Nissan 350Z 2007-2008

Nissan Maxima 2007-2008



Click image to see an enlarged view

Fig. Sunroof motor testing



Click image to see an enlarged view

Fig. Sunroof motor harness pinout

Switch

Specific to:

Nissan 350Z 2007-2008

Nissan Maxima 2007-2008

  1. Turn ignition switch OFF.
  2.  
  3. Disconnect sunroof switch.
  4.  
  5. Operate sunroof switch and check continuity between terminals 1 and 3, and terminals 2 and 3 on the sunroof switch connector R6 in each of the switch positions:

    Tilt up position: terminals 2 to 3, continuity should exist
     
    Tilt down position: terminals 1 to 3, continuity should exist
     

  6.  
  7. If NG, replace switch.
  8.  
  9. Operate sunroof slide switch and check resistance between terminals 3 and 4 on the sunroof switch in each of the switch positions.

    Switch position 1 (fully closed): terminals 3 to 4: 120 Ohms
     
    Switch position 2: terminals 3 to 4: 220 Ohms
     
    Switch position 3: terminals 3 to 4: 390 Ohms
     
    Switch position 4: terminals 3 to 4: 680 Ohms
     
    Switch position 5: terminals 3 to 4: 1300 Ohms
     
    Switch position 1 (fully open): terminals 3 to 4: 3600 Ohms
     

  10.  

Removal & Installation
Motor

Specific to:

Nissan 350Z 2007-2008

Nissan Maxima 2007-2008

  1. Position glass lid assembly in the fully closed position.
  2.  
  3. Remove roof console assembly.
  4.  
  5. Remove the sunroof motor screws
  6.  
  7. Disconnect sunroof motor harness connector, then remove sunroof motor.
    NOTE
    When removing the sunroof motor (1), be sure that the sunroof is in the fully closed position. Never run the removed sunroof motor as a single unit.

  8.  

To install:

  1. Move the sunroof motor laterally little by little so that the gear is completely engaged into the wire on the sunroof unit and the surfaces becomes parallel. Then secure the sunroof motor with the screws to 23 inch lbs. (2.6 Nm).
    NOTE
    Before installing the sunroof motor, be sure to place the link and wire assembly in the symmetrical and fully closed position.

  2.  
  3. The remainder of installation is in the reverse order of removal.
  4.  

Switch

Specific to:

Nissan 350Z 2007-2008

Nissan Maxima 2007-2008

  1. Remove roof console assembly.
  2.  
  3. Remove switch assembly from console.
  4.  

To install:

  1. Installation is reverse of removal.
  2.  

 
label.common.footer.alt.autozoneLogo