Maxima 2007

Tire Pressure Monitor System

Print

Precautions



See Precautions at the beginning of the article.

Servicing



ID Registration With Activation Tool

Specific to:

Nissan 350Z 2007-2008

Nissan Maxima 2007-2008


NOTE
This procedure must be done after replacement of a low tire pressure warning transmitter or BCM. New replacement transmitters are provided "asleep" and must first be "woken up" using Transmitter Activation Tool J-45295 before ID registration can be performed.

  1. Connect CONSULT-III®.
  2.  
  3. Select -AIR PRESSURE MONITOR- on "SELECT TEST ITEM" screen.
  4.  
  5. Select -WORK SUPPORT- on "SELECT DIAG MODE" screen, and select "ID REGIST".
  6.  
  7. Push the transmitter activation tool against the tire near the front left transmitter. Press the button for 5 seconds.
  8.  
  9. Register the IDs in order from FR LH, FR RH, RR RH and RR LH. When ID registration of each wheel has been completed, a buzzer sounds and the hazard warning lamps flash. Buzzer occurs as follows: LF once, RF 2 times, RR 3 times, LR 4 times.
  10.  
  11. After completing all ID registrations, press -END- to complete the procedure.
    NOTE
    Be sure to register the IDs in order: LF, RF, RR, LR, or the self-diagnostic results display will not function properly.

  12.  

ID Registration Without Activation Tool

Specific to:

Nissan 350Z 2007-2008

Nissan Maxima 2007-2008


NOTE
This procedure must be done after replacement of a low tire pressure warning transmitter or BCM. New replacement transmitters are provided "asleep" and must first be "woken up" using Transmitter Activation Tool J-45295 before ID registration can be performed.

  1. Connect CONSULT-III®.
  2.  
  3. Select -AIR PRESSURE MONITOR- on "SELECT TEST ITEM" screen.
  4.  
  5. Select -WORK SUPPORT- on "SELECT DIAG MODE" screen, and select "ID REGIST".
  6.  
  7. Adjust the tire pressure to the values to: LF 36 psi, RF 33 psi, RR 30 psi, LF 27 psi, for ID registration, and drive the vehicle at 9.4 MPH (15 km/h) or more for a few minutes.
  8.  
  9. After completing all ID registrations, press -END- to complete the procedure. CONSULT-III® should display -Yet- -Done- for all tire positions.
  10.  
  11. After completion, inflate all tires to proper pressure.
  12.  

 
label.common.footer.alt.autozoneLogo