Mazda 323/626/929/GLC/MX-6/RX-7 1978-1989

Brake Light Switch

Print

REMOVAL & INSTALLATION



See Figure 1

  1. Detach the electrical connector from the switch.
  2.  
  3. Loosen the locknut and adjusting nut, then remove the switch from the mounting bracket above the brake pedal.
  4.  



Click image to see an enlarged view

Fig. Fig. 1: The brake light switch is usually fastened to its bracket with two nuts

To install:
  1. Position the switch into the mounting bracket and secure with the attaching nuts.
  2.  
  3. Turn the brake light switch until it makes contact with the pedal, and then an additional 1 / 2 turn. Tighten the locknut.
  4.  
  5. Connect the electrical wiring and check the operation of the switch.
  6.  

 
label.common.footer.alt.autozoneLogo