Mazda B-Series 1998-06

Removal & Installation

Print



Click image to see an enlarged view

Fig. Exploded view of the blower motor mounting



Click image to see an enlarged view

Fig. Exploded view of the blower motor and wheel (fan) assembly

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the retaining screw and reposition the cruise control servo out of the way.
  4.  
  5. In the engine compartment, disconnect the wire harness from the motor by lifting up on the tab while pulling the connection off at the motor.
  6.  
  7. Disconnect the blower motor cooling tube from the blower motor.
  8.  
  9. Remove the blower motor mounting plate attaching screws and remove the motor and wheel assembly from the blower motor housing.
  10.  
  11. Remove the blower motor hub clamp from the motor shaft and pull the blower wheel from the shaft.
  12.  

To install:

  1. Install the blower motor wheel on the blower motor shaft and install a new hub clamp.
  2.  
  3. Position the blower motor and wheel assembly in the blower housing and install the attaching screws.
  4.  
  5. Connect the blower motor cooling tube.
  6.  
  7. Connect the electrical wire harness hard shell connector to the blower motor by pushing into place.
  8.  
  9. Install the cruise control servo back into position and tighten the retaining screw.
  10.  
  11. Connect the negative battery cable and check the blower motor in all speeds for proper operation.
  12.  

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Remove the RH A-pillar lower trim.
  6.  
  7. Disconnect the electrical connector.
  8.  
  9. Remove the washer screws.
  10.  
  11. Remove the blower motor and cover, lower the assembly from the housing.
  12.  
  13. To install, reverse the removal procedure.
  14.  

 
label.common.footer.alt.autozoneLogo