Mazda B-Series 1998-06

2.3L L4 VIN D Auto 1

Print

2.3L L4 VIN D Auto

Trouble Code: P0171



Adaptive Fuel Trim Too Lean (Bank 1)

Possible Causes:



Air leaks after the MAF sensor, or in the PCV or EGR system
 
Base engine -mechanical- fault affecting one or more cylinders
 
Exhaust leaks before or near where the front HO2S is mounted
 
Fuel control sensor out of calibration (i.e., ECT, IAT or MAF)
 
Fuel delivery system supplying too much or too little fuel during idle or cruise speed (weak fuel pump, weak pressure regulator)
 
Fuel Injectors (one or more) is dirty, restricted or leaking fuel
 
HO2S is contaminated, deteriorated or it has failed
 
Vehicle driven low on fuel or driven until it ran out of fuel
 

Trouble Code: P0703



Brake On/Off Switch Circuit Malfunction (Self-Test)

Possible Causes:



Brake switch signal circuit is open or shorted ground
 
Brake switch power circuit (B+) is open or shorted to ground
 
Brake switch is damaged, misadjusted or installed improperly
 
PCM has failed
 

Trouble Code: P0705



Digital Transmission Range Switch Circuit Malfunction

Possible Causes:



TR4 signal circuit is open or shorted to ground (0v or 12v)
 
TR3A signal circuit is open or shorted to ground (0v or 12v)
 
TR2 signal circuit is open or shorted to ground (0v or 12v)
 
TR1 signal circuit is open or shorted to ground (0v or 12v)
 
DTR switch or its connector is damaged, or switch has failed
 
PCM has failed
 

Trouble Code: P0708



Digital Transmission Range Switch Circuit Malfunction

Possible Causes:



TR switch signal circuit open between switch and the PCM (0v)
 
DTR switch or its connector is damaged, or switch has failed
 
PCM has failed
 

Trouble Code: P0712



Transmission Fluid Temperature Sensor Low Input (High Temperature)

Possible Causes:



TFT sensor signal circuit has a short to ground condition
 
TFT sensor is damaged or has failed (it may be shorted)
 
PCM has failed
 

Trouble Code: P0713



Transmission Fluid Temperature Sensor High Input (Low Temperature)

Possible Causes:



TFT sensor signal circuit is open between sensor and the PCM
 
TFT sensor signal circuit has a short to power condition
 
TFT sensor is damaged or has failed (it may be open)
 
PCM has failed
 

Trouble Code: P0715



Turbine Shaft Sensor Circuit Malfunction

Possible Causes:



TSS (+) signal circuit is open (an intermittent fault)
 
TSS (+) signal circuit shorted to ground (intermittent fault)
 
TSS (-) signal circuit is open (an intermittent fault)
 
TSS (-) signal circuit shorted to ground (intermittent fault)
 
TSS is damaged or has failed
 
PCM has failed
 

Trouble Code: P0720



Output Shaft Sensor Circuit Malfunction

Possible Causes:



OSS (+) signal circuit is open (fault may be intermittent)
 
OSS (+) signal circuit shorted to ground (an intermittent fault)
 
OSS (-) signal circuit is open (fault may be intermittent)
 
OSS (-) signal circuit shorted to ground (an intermittent fault)
 
OSS is damaged or has failed
 
PCM has failed
 

Trouble Code: P0735



Output Shaft Sensor Circuit Erratic Malfunction

Possible Causes:



OSS (+) signal circuit is open or shorted to ground (intermittent)
 
OSS (-) signal circuit is open or shorted to ground (intermittent)
 
OSS reluctor contains metal chips or is damaged
 
OSS is damaged or has failed
 
PCM has failed
 

Trouble Code: P0755



A/T Shift Solenoid -B- Circuit Malfunction

Possible Causes:



SSB control circuit is open (continuous high signal)
 
SSB control circuit is shorted to ground (continuous low signal)
 
SSB control circuit is shorted to system power (B+)
 
SSB is damaged or has failed
 
PCM has failed
 

Trouble Code: P0760



A/T Shift Solenoid -C- Circuit Malfunction

Possible Causes:



SSC control circuit is open (continuous high signal)
 
SSC control circuit is shorted to ground (continuous low signal)
 
SSC control circuit is shorted to system power (B+)
 
SSC is damaged or has failed
 
PCM has failed
 

Trouble Code: P0761



A/T Shift Solenoid -C- Performance (Mechanical)

Possible Causes:



ATF level is too low, or the ATF is badly deteriorated
 
A/T SSC is stuck -off-, or it is damaged (a mechanical fault)
 
A/T control valve is stuck, or it is damaged (a mechanical fault)
 
PCM has failed
 

Trouble Code: P0765



A/T Shift Solenoid and TCC Solenoid Performance

Possible Causes:



ATF level is too low, or the ATF is badly deteriorated
 
A/T SSA, SSB, SSC, SSD or TCC is stuck -off-, or it is damaged (a mechanical fault)
 
A/T control valve is stuck, or it is damaged (a mechanical fault)
 
PCM has failed
 

Trouble Code: P0791



Input Shaft Speed (ISS) Sensor

Possible Causes:



Input Shaft Speed Sensor circuit is open
 
ISS circuit is shorted to ground
 
ISS circuit is shorted to system power (B+)
 
ISS Sensor is damaged or has failed
 
PCM has failed
 

Trouble Code: P0794



Input Shaft Speed (ISS) Sensor

Possible Causes:



ISS circuit is open
 
ISS circuit is shorted to ground
 
ISS circuit is shorted to system power (B+)
 
ISS sensor is damaged or has failed
 
PCM has failed
 

Trouble Code: P1605



PCM Keep Alive Memory or Read Only Memory Test Error

Possible Causes:



Battery cables are loose, or the connections are corroded
 
Keep Alive Power circuit to the PCM is shorted to ground
 
Keep Alive Power circuit to the PCM is open (intermittent fault)
 
PCM has failed
 

Trouble Code: P1702



Transmission Range Sensor Circuit Malfunction

Possible Causes:



TR sensor signal circuit is open (an intermittent fault)
 
TR sensor signal circuit is shorted to ground (intermittent fault)
 
TR sensor signal circuit is shorted to VREF (intermittent fault)
 
TR sensor is damaged or has failed (an intermittent fault)
 
PCM has failed
 

Trouble Code: P1703



Brake Switch Circuit Malfunction (Self-Test)

Possible Causes:



Brake not depressed at the proper time during KOEO Self-Test.
 
Brake was depressed at all times during the KOEO Self-Test.
 
Brake was not cycled "on" and "off" during the KOER Self-Test.
 
Brake switch signal circuit shorted to system power (B+)
 
Brake switch is damaged or has failed, or is out of adjustment
 
PCM has failed
 

Trouble Code: P1704



Transmission Range Sensor Circuit Malfunction (Self-Test)

Possible Causes:



TR switch signal circuit is open or shorted to ground
 
TR switch is damaged, has failed or is out of adjustment
 
Transmission shift cable is damaged or out-of-adjustment
 
PCM had failed
 

Trouble Code: P1705



Digital Transmission Range Sensor Circuit Malfunction (Self-Test)

Possible Causes:



The gear selector was not In Park during the Self-Test
 
TR switch is damaged, has failed or is out of adjustment
 
Starter or starter relay is damaged or has failed
 
Backup lamp circuit is open or shorted
 
PCM had failed
 

Trouble Code: P1711



Transaxle Fluid Temperature Sensor Circuit Malfunction (Self-Test)

Possible Causes:



ATF level is too low
 
ATF temperature not at operating temperature during the test
 
TFT sensor is damaged or has failed
 
PCM has failed
 

Trouble Code: P1714



Transmission Shift Solenoid 'A' Mechanical Malfunction

Possible Causes:



ATF level is low, or the fluid is contaminated
 
SSA has failed (mechanically) or is damaged
 
PCM has failed
 

Trouble Code: P1715



Transmission Shift Solenoid 'B' Mechanical Malfunction

Possible Causes:



ATF level is low, or the fluid is contaminated
 
SSB has failed (mechanically) or is damaged
 
PCM has failed
 

Trouble Code: P1716



Transmission Shift Solenoid 'C' Mechanical Malfunction

Possible Causes:



ATF level is low, or the fluid is contaminated
 
SSC has failed (mechanically) or is damaged
 
PCM has failed
 

Trouble Code: P1717



Transmission Shift Solenoid 'D' Mechanical Malfunction

Possible Causes:



ATF level is low, or the fluid is contaminated
 
SSD has failed (mechanically) or is damaged
 
PCM has failed
 

Trouble Code: P1718



Transaxle Fluid Temperature Sensor Circuit Malfunction

Possible Causes:



ATF level is low
 
TFT sensor is damaged (it may be out-of-calibration)
 
TFT sensor signal circuit shorted to power (intermittent fault)
 
PCM has failed
 

Trouble Code: P1729



Transmission 4x4 Low Switch Error

Possible Causes:



4x4L (low switch) signal circuit is open or shorted to ground
 
4x4L shift control switch is damaged or has failed
 
Electronic shift control module is damaged or has failed
 
PCM has failed
 

Trouble Code: P1740



Torque Converter Clutch Solenoid Malfunction (Mechanical)

Possible Causes:



ATF level is low, or the fluid is contaminated
 
A/T shift solenoid is damaged (mechanical fault) or has failed
 
PCM has failed
 

Trouble Code: P1743



Torque Converter Clutch Solenoid Circuit Malfunction

Possible Causes:



TCC solenoid control circuit has failed in the "on" position
 
TCC solenoid control circuit is shorted to ground
 
TCC solenoid is damaged or has failed
 
PCM is damaged
 

Trouble Code: P1746



Electronic Pressure Control Solenoid Circuit Malfunction

Possible Causes:



EPC solenoid control circuit is open
 
EPC solenoid control circuit is shorted to system power (B+)
 
EPC solenoid is damaged or has failed
 
PCM has failed
 

Trouble Code: P1747



Electronic Pressure Control Solenoid Circuit Malfunction

Possible Causes:



EPC solenoid control circuit open between solenoid and PCM
 
EPC solenoid control circuit is shorted to ground
 
EPC solenoid is damaged or has failed
 
PCM has failed
 

Trouble Code: P1754



Transmission Coast Clutch Solenoid Circuit Malfunction

Possible Causes:



CCS control circuit is open
 
CCS control circuit is shorted to ground
 
CCS control circuit is shorted to power
 
CCS is damaged or has failed
 
TCM has failed
 

Trouble Code: P1780



Transmission Control Switch Circuit Malfunction (Self-Test

Possible Causes:



TCS switch not cycled at the proper time in the KOER Self-Test
 
TCS switch signal circuit is open or shorted to ground
 
TCS switch signal circuit is shorted to VREF or system power
 
TCS switch is damaged, out-of-adjustment or has failed
 
PCM has failed
 

Trouble Code: P1781



Transmission 4x4 Low Switch Circuit Malfunction

Possible Causes:



4x4 switch not cycled at the correct time during the Self-Test
 
4x4 switch signal circuit is open or shorted to ground
 
4x4 switch signal circuit is shorted to VREF or system power
 
4x4 switch is damaged or has failed
 
PCM has failed
 

Trouble Code: P1783



Transmission Fluid Temperature Sensor Circuit High Input

Possible Causes:



ATF level is low, or the fluid is contaminated or burnt
 
Vehicle driven with excessive loads, or trailer towing conditions
 
TCC clutch is damaged or has failed (it may be slipping)
 
TFT sensor signal circuit is open (an intermittent fault)
 
Transaxle cooling system is damaged or has failed
 
PCM has failed
 

Trouble Code: P1900



Output Speed Sensor Circuit Malfunction

Possible Causes:



OSS signal circuit is open (an intermittent fault)
 
OSS signal circuit is shorted to ground (an intermittent fault)
 
OSS signal circuit is shorted to system power (intermittent fault)
 
OSS is damaged or has failed (an intermittent fault)
 
PCM has failed
 

Trouble Code: U0073



Data Circuit Malfunction

Possible Causes:



SCP data bus to other controller(s) is open or shorted to ground
 
A/C System controller is damaged or has failed
 
PCM has failed
 

Trouble Code: U0101



Data Circuit Malfunction

Possible Causes:



SCP data bus to other controller(s) is open or shorted to ground
 
A/C System controller is damaged or has failed
 
PCM has failed
 

Trouble Code: U0121



Data Circuit Malfunction

Possible Causes:



SCP data bus to other controller(s) is open or shorted to ground
 
A/C System controller is damaged or has failed
 
PCM has failed
 

Trouble Code: U0155



Data Circuit Malfunction

Possible Causes:



SCP data bus to other controller(s) is open or shorted to ground
 
A/C System controller is damaged or has failed
 
PCM has failed
 

 
label.common.footer.alt.autozoneLogo