Mazda B-Series 1998-06

Manual Transmission


Drain & Refill

Under normal conditions, the manufacturer feels that manual transmission fluid should not need to be changed. However, if the truck is driven in deep water (as high as the transmission casing) it is a good idea to replace the fluid. Little harm can come from a fluid change when you have just purchased a used vehicle, especially since the condition of the transmission fluid is usually not known.

If the fluid is to be drained, it is a good idea to warm the fluid first so it will flow better. This can be accomplished by 15-20 miles of highway driving. Fluid which is warmed to normal operating temperature will flow faster, drain more completely and remove more contaminants from the housing.

  1. Drive the vehicle to assure the fluid is at normal operating temperature.
  3. Raise and support the vehicle securely on jackstands. Remember that the vehicle must be supported level (usually at four points) so the proper amount of fluid can be added.
  5. Place a drain pan under the transmission housing, below the drain plug. Remember that the fluid will likely flow with some force at first (arcing outward from the transmission), and will not just drip straight downward into the pan. Position the drain pan accordingly and move it more directly beneath the drain plug as the flow slows to a trickle.

To insure that the fill plug is not frozen or rusted in place, remove it from the transmission BEFORE removing the drain plug. It would be unfortunate to drain all of your transmission fluid and then realize that the fill plug is stripped or frozen in place.

  1. Remove the fill plug, then the drain plug and washer, allowing the transmission fluid to drain out.

The transmission drain plug may have a square receiver which is designed to accept a 3 / 8 in. driver such as a ratchet or extension.

  1. Once the transmission has drained sufficiently, install the drain plug, with a new washer, until secure. Tighten the drain plug to 30-42 ft. lbs. (40-58 Nm).
  3. Fill the transmission with the specified amount and type of oil through the hole until the level reaches the bottom of the hole.
  5. Install the filler plug, with a new washer, once you are finished.
  7. Remove the jackstands and carefully lower the vehicle.

Fluid Level Check

The fluid level should be checked every six months or 60,000 miles (96,000 km), whichever comes first.

  1. Park the truck on a level surface, turn the engine OFF , FIRMLY apply the parking brake and block the drive wheels.

Ground clearance may make access to the transmission filler plug impossible without raising and supporting the vehicle, BUT, if this is done, the truck MUST be supported at four corners and level. If only the front or rear is supported, an improper fluid level will be indicated. If you are going to place the truck on four jackstands, this might be the perfect opportunity to rotate the tires as well.

  1. Remove the filler plug from the side of the transmission case using a 3 / 8 in. drive ratchet and extension. The fluid level should be even with the bottom of the filler hole.
  3. If additional fluid is necessary, add it through the filler hole using a siphon pump or squeeze bottle.
  5. When you are finished, carefully install the filler plug, but DO NOT overtighten it and damage the housing.

Fluid Recommendations

The lubricant in the transmission should be checked and changed periodically, except when the vehicle has been operated in deep water and water has entered the transmission. When this happens, change the lubricant in the transmission as soon as possible. Use ATF DEXRON®-II, M-III or MERCON® in the Mazda M5OD transmission.