Mazda B-Series 1998-06

Seats

Print

Power Seat Motor



The optional six-way power seat system on the Navajo uses a screw-type drive for seat adjustment.

The six-way power seat provides horizontal, vertical, and tilt adjustments. It consists of a reversible armature motor, switch and housing assembly, vertical screw, and horizontal screw drives.

The motor assembly, which contains three armatures, the flexible shafts, the screw drive and gear mechanism are not serviced individually and can be serviced only by replacing the complete track assembly.

Removal & Installation



Navajo And B Series Pick-Up
Bench Seat


Click image to see an enlarged view

Fig. B Series Pick-up bench seat

  1. On the right side, remove the seat track insulator.
  2.  
  3. Remove 4 seat track-to-floor retaining screws (2 each side) and lift the seat and track assembly from vehicle.
  4.  
  5. To remove the tracks from the seat, place the seat upside-down on a clean bench.
  6.  
  7. Disconnect the track latch tie rod assembly from latch lever and hook in the center of the cushion assembly.
  8.  
  9. Remove 4 track-to-seat cushion retaining screws (2 each side) and remove the tracks from the cushion assembly.
  10.  

To install:

  1. Position the track to the cushion assembly. Install the 4 track-to-seat retaining screws and tighten.
  2.  
  3. Connect the track latch tie rod assembly to the latch lever and hook in center of cushion.
  4.  
  5. Position the seat and track assembly in the vehicle.
  6.  
  7. Install the 4 seat track-to-floor retaining screws and tighten to specification.
  8.  
  9. On the right side, install the seat track insulator.
  10.  

Bucket & 60/40 Seats


Click image to see an enlarged view

Fig. B Series Pick-up bucket seat



Click image to see an enlarged view

Fig. Navajo bucket seat



Click image to see an enlarged view

Fig. 60/40 split seat-Navajo

  1. Remove the seat track insulator (B Series Pick-up passenger seat only).
  2.  
  3. Remove the 4 seat track-to-floorpan screws (2 each side) and lift the seat and track assembly from the vehicle.
  4.  
  5. To remove the seat tracks from the seat cushion, position the seat upside down on a clean bench.
  6.  
  7. Disconnect the latch tie rod assembly and assist spring from the tracks.
  8.  
  9. Remove 4 track-to-seat cushion screws (2 each side) from the track assemblies. Remove the tracks from seat cushion.
  10.  

To install:

  1. Position the tracks to the seat cushion. Install the 4 track-to-seat cushion screws (2 each side) and tighten.
  2.  
  3. Connect the latch tie rod assembly and assist spring to the tracks.
  4.  
  5. Position the seat and track assembly in the vehicle.
  6.  
  7. Install 4 track-to-floorpan screws and tighten to specification.
  8.  
  9. Install the seat track insulators (B Series Pick-up passenger seat only).
  10.  

 
label.common.footer.alt.autozoneLogo